University of Nottingham Department of Electrical and Electr
Your report should be around 3000-4000 words and include diagrams and other appropriate data. Your report should be submitted on or before Tues 1st May 2012. You are reminded that late submission of coursework will result in marks being deducted.
Virgin Island is a remote island with one major city, Media, in the north covering an area of 100km2 (slightly less than the size of London) within which there is a densely populated centre of approximately 100km2. The density of users in the city centre is 500/km2 and in the suburban areas is 100/km2. The rest of the island is sparsely populated with an average number of users of 5/km2.
The Government of Virgin Island would like to set up a mobile communications network based on CDMA (code division multiple access) technology and asks you to write a proposal for the structure of the network. There are competing bids to be a service provider. The Government is making available the frequency bands 890-915MHz for the uplink and 935-960MHz for the downlink. The Government are interested in implementing a wireless communication system and would like you to consider 2 options;
1) A voice only network with a required user data rate of 10kbps
2) A voice and data network with a voice user data rate of 10kbps and the data rate for other traffic (e.g. internet data) of 150kbps.
The report should cover the main aspects of a mobile communication system;
• Bandwidth requirements of the system
• Cell size and capacity in the different regions to cope with the demands of users
• Modulation technique on uplink and downlink
• Error detection and correction methods
• Any other regulatory/business/user requirements that should be considered.
You should justify your choices based on both a literature review and calculations and graphs comparing the different design options. In some instances you may need to do your own research about particular parameters that have not been specified here e.g. ‘typical’ usage time of voice and data services by users, http://www.ukthesis.org/thesis_sample/ acceptable bit error to interference ratios for voice and other data, blocking probabilities. Where appropriate, you could consider writing short pieces of MATLAB or C-code to generate the data required to plot the graphs. You might also want to consider implementing a link budget calculation and/or calculations of blocking probabilities.
There is sufficient information available in the lecture notes for you to obtain an adequate pass of this module. However to achieve a good mark you will need to perform additional research. The main purpose of this project is to assess your ability to make design choices for a mobile communications system. As has been demonstrated in the development of different systems in the US and Europe, there is no single correct solution. Please justify your design choices and do not simply copy an existing system.#p#分页标题#e#
There are many references available in the library and online for design and planning of networks. You may find the following a useful starting point;
1) WCDMA for UMTS : radio access for third generation mobile communications / edited by Harri Holma and Antti Toskala. (Wiley 2004) (Chapter 8)
2) W-CDMA and cdma2000 for 3G mobile networks / M.R. Karim and M. Sarraf. (McGraw-Hill 2002) (Chapter 10)
3) 3G Wireless Networks, D Collins, C Smith (McGraw-Hill 2002) (Chapter 12)
(All are available as electronic books at the library, there are many more 3G/4G books available)
Dr Paul Rodmell
January 2012
